Installation steps for fire door hinges

Pre-Installation Preparation

Before installing fire door hinges, make sure to follow these steps:

1. Check the door and frame for any damage or defects that may affect the installation process.
2. Ensure that the door and frame are properly aligned and level.
3. Verify that the hinges meet the necessary fire rating requirements for the building.
4. Gather all necessary tools and hardware, including screws and a drill.

Installation Process

Follow these steps to install fire door hinges:

1. Place the hinge on the door and mark the screw hole locations with a pencil.
2. Drill pilot holes for the screws using a drill bit that is slightly smaller than the screw size.
3. Attach the hinge to the door using screws and a screwdriver.
4. Repeat the process for the remaining hinges on the door.
5. Place the door in the frame and align the hinges with the pre-drilled holes in the frame.
6. Attach the hinges to the frame using screws and a screwdriver.

Post-Installation Inspection

After installing fire door hinges, it is important to conduct a thorough inspection to ensure that the door is functioning properly. Follow these steps:

1. Open and close the door to verify that it is aligned and level.
2. Check that the door is properly latching and that there is no visible gap between the door and frame.
3. Verify that the hinges are securely attached to both the door and frame.
4. Ensure that the door swings freely without any binding or rubbing against the frame or floor.
5. If any issues are found during the inspection, make the necessary adjustments or repairs before using the door.